Table of Contents
Advertisement
Main Menu Buttons -
Installation Settings
Aux In Use
The wired sensor may be used as follows:
• Use as outdoor sensor
• Use as remote sensor
• Use as supply sensor
The first four options allow you to connect a 10K thermistor to the
SENSOR terminals to be used to monitor a temperature (outdoor,
supply, return) or control to a temperature (remote). The last two
options allow you to connect a dry contact signal that will simply
short the two SENSOR terminals to detect a Condensate overflow
switch or a fault/alarm signal. Note that on ClimateMaster
equipment, the condensate overflow sensor is connected to the
control board such that an actual condensate overflow event causes
the control board to lock out and generate a fault condition that can
be detected by the thermostat. In this case, set AUX IN use to the
Fault Detect setting.
Calibrate Sensors
The thermostat and wired sensor may be calibrated -7 to +7 degrees F .
The integral humidity sensor may be calibrated -20% to +20% RH
• Thermostat
• Wired Sensor
• Humidity
Test Outputs
The installer or service
technician can use this
feature to test the
functions without any
time delays of the
thermostat.
Settings
(Continued)
(remote)
• Use as return sensor
• Condensate overflow
• Fault Detect
(0˚)
With a 1st stage cooling call, Y1 and G are active
60
Advertisement
Table of Contents
