Table of Contents
Advertisement
Main Menu Buttons -
Installation Settings
Fan Off Delay
Runs the fan for a short time after Cooling or electric strip heat
turns off to increase system efficiency. (0 - 120 Secs.)
Sensor Settings
Control Source
When a remote sensor is connected to the thermostat, the user may
choose which sensor source is used to measure room temperature.
• Thermostat sensor only
• Wired sensor only
• Average all wireless sensors
• Average wired/thermostat
• Average wireless/thermostat
• Average all available sensors
Wireless Sensors
You may pair multiple Wi-Fi remote sensors to the thermostat to
be used for temperature monitor or control. The sensors MUST be
on the same Wi-Fi network as the thermostat. Skyport connectivity
is not required. Start the pairing process by pressing the LINK
button on the Wi-Fi sensor. This will cause it to send a message to
the Wi-Fi router that will in turn broadcast that message. Any
thermostat on the network should hear that broadcast and store
information about the sensor. Use this section to Add New Sensor
for use by the thermostat (pair) or Remove sensor to quit listening
to a sensor (unpair). Multiple thermostats can pair to the same
sensor (handy for outdoor sensor use) or pair to a group of
sensors (average multiple sensors in a large space served by
multiple units).
Add New Sensor
Remove Sensor
Settings
(Continued)
(thermostat )
59
(0s)
Advertisement
Table of Contents
