FireClass Precept EN Installation & Commissioning Manual
Output expansion module
Hide thumbs
Also See for Precept EN:
- Installation & commissioning manual (30 pages) ,
- Application manual (38 pages)
Related Manuals for FireClass Precept EN
Summary of Contents for FireClass Precept EN
- Page 1 Precept EN Output Expansion Module Installation & Commissioning Manual PAGE 1 of 21 www.acornfiresecurity.com...
-
Page 2: Table Of Contents
FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: List of Contents 1. I ............3 List of Figures NTRODUCTION 2. O VERVIEW OF NSTALLATION AND OMMISSIONING 1 –... -
Page 3: Introduction
& output modules. FIRECLASS Precept EN Exp 4 and 5 output expansion panels are supplied with or without a C1652 230Vac 5A PSU depending on the output load requirement. When fitted, the PSU is located on the chassis underneath the output modules. -
Page 4: Precept En - Internal Panel
BATTERY FUSE BATT THERM Motherboard Batteries Batteries Figure 5 – Precept EN 16L internal view [32 zone enclosure] with two Output boards Secondary Earth bars 3 x Enclosure Cable Clip for incoming Mains Warning / for cable screens fixing holes... - Page 5 FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Figure 6 – Precept EN Exp 5 internal view Secondary Earth bars 3 x Enclosure Cable Clip for incoming Mains Warning / for cable screens...
-
Page 6: Installation
This equipment requires a 230V AC supply. [See Rating Plate inside equipment. See also section Precept EN Exp 4 and Precept EN Exp 5 Output 3. ] All installation work should be carried out in Expansion panels must be located immediately... -
Page 7: Precept En 16 Exp Installation Instructions
Matching 25mm knock-outs are provided on the output expansion module system provided. right hand face of the Precept EN 8/16 fire alarm panel enclosure and the left hand face of the Precept EN 4 Exp output expansion enclosure to Table 1 –... -
Page 8: Interconnections Between
FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: 6.2.3 Interconnections between Fire Alarm Panel and Output Modules The standard output expansion panel combinations are listed below [see Table 2] along with their respective requirements for interconnection for the 3 types of O/P modules. - Page 9 FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Internal Connections Schematic FIRECLASS Expansion Panel Internal Precept EN Panel Main Panel Expansion Panel Cable Data out...
-
Page 10: Installation Of The Expansion Interface
FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: 6.2.4 Installation of the C1630 Output before the interface board can be fitted]. The board should be held in place by the 12mm high Expansion Interface plastic spacer provided. -
Page 11: Commissioning
FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Table 4 – Setting C1633 Zone Range 7. Commissioning Function The commissioning guidelines provided in the... -
Page 12: Table 5 - Setting C1634 B
FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Table 5 – Setting C1634 Board Address Table 7 – Setting C1634 Function Function Function Fire Protection module... -
Page 13: C1635 8- Way Alarm
FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Table 9 – Setting C1635 Type, General/Zonal 7.1.2 C1635 8-way alarm/monitored Response and Zone range output module configuration. -
Page 14: Configuration
ISSUE No. & DATE: 2. Use the Alarm Test facility [see FIRECLASS 7.1.3 C1630 Output Interface Precept EN User Manual] or press Evacuate to Configuration operate the sounders. Check that all sounders Table 10 – Setting Quantity and Type of O/P connected to the alarm circuit operate. -
Page 15: Outputs
5. Disable the Fire Protection Outputs via the 2. The correct operation of equipment connected to Precept EN panel [see Precept EN Operating these outputs should be verified in turn by Instructions]. Initiate a fire condition on a zone to... - Page 16 FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Figure 12 – 8/16 zone panel with internal O/P Modules and Exp 4 Output Module Panel with no PSU PAGE 16 of 21 www.acornfiresecurity.com...
- Page 17 FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Figure 13 – 8/16 zone panel and Exp 4 Output Module Panel with no PSU PAGE 17 of 21...
- Page 18 FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Figure 14 – 8, 16 or 32 zone panel & Exp 5 Output Module Panel with 5 Amp PSU PAGE 18 of 21 www.acornfiresecurity.com...
- Page 19 FIRECLASS PRECEPT EN EQUIPMENT: WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Figure 15 – 32 zone panel & Exp 5 Output Module Panel with no PSU PAGE 19 of 21...
- Page 20 WRITTEN BY: RKP FIRECLASS PREC EN OUTPUT EXP MOD INST PUBLICATION: CHECKED BY: AP 02/03/12 ISSUE No. & DATE: Figure 16 – Precept EN 16L with internal O/P Modules and Exp 4 Output Module Panel with PSU PAGE 20 of 21 www.acornfiresecurity.com...