BRP Evinrude E-TEC 40 Operator's Manual page 66

Maintenance
Outboard continues to run at slow idle
speed.
3) After outboard runs for another 15 sec-
onds:
For side mount controls, fully raise the
fast idle lever again.
For binnacle or concealed side mount
controls, fully advance throttle handle
again.
Outboard will accelerate to fast idle speed
and fog itself.
4) Allow outboard to run until it shuts itself
OFF automatically (one to two minutes).
Winterization is complete when outboard
shuts itself off.
• If the outboard DOES NOT shut itself off,
you may not have used the fast idle lever or
button and the outboard was shifted into
gear.
• If the engine exceeds 3000 RPM, the out-
board may have been shifted into gear.
In either event, immediately turn the key
switch OFF and re-start the procedure.
64
Tiller Control Outboards
1) Fully advance throttle grip. Start the out-
board. Outboard runs at slow idle speed.
006458
Tiller Control – Typical
2) After outboard runs for at least 15 sec-
onds, move throttle grip to IDLE position.
Outboard continues to run at slow idle
speed.
006459
3) After outboard runs for another 15 sec-
onds, fully advance the throttle grip again.
Outboard will accelerate to fast idle speed
and fog itself.
4) Allow outboard to run until it shuts itself
OFF automatically (one to two minutes).
Winterization is complete when outboard
shuts itself off.
• If the outboard DOES NOT shut itself off,
you may not have used the fast idle lever or
button and the outboard was shifted into
gear.
• If the engine exceeds 3000 RPM, the out-
board may have been shifted into gear.
In either event, immediately turn the key
switch OFF and re-start the procedure.
007036
007037
007038