BRP Evinrude E-TEC 40 Operator's Manual page 34

Using Your Evinrude E-TEC Outboard
OFF
1
1. Key switch START position
Upon start-up, release the key.
If the engine did not start, release the key mo-
mentarily, then try again.
Each time the key switch is turned from OFF
to ON, the warning system will self-test. Refer
to Engine Monitoring on page 44. If the
warning system fails to self-test during start-
up, see your Dealer.
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 67.
After Engine Starts
Check the water pump indicator. A steady
stream of water indicates the water pump is
working. If a steady stream of water from the
water pump indicator is not visible, stop the
engine. Refer to Engine Overheating on
page 45.
1. Water pump indicator
32
Engine Stopping
Move control handle to NEUTRAL.
ON
Turn key switch counterclockwise to the OFF
position.
START
Key
007015A
1. Key switch, OFF position
Remove the key when the boat will be unat-
tended.
Disconnecting the Fuel Hose
A small amount of fuel may be released
when the fuel connector is discon-
nected. Always wipe off any fuel spillage.
Disconnect the fuel hose from the fuel con-
nector.
1
1. Fuel connector (typical)
If equipped, close vent screw on fuel tank cap.
008469
OFF
1
WARNING
ON
START
007072
1
007004