Siemens VersiCharge AC Quick Start Installation Manual page 5

Kit Supplied
Equipment
1 – Mounting Bracket
2 – Lag Screws, Hex Head
screws, 1/4 x 2" (for
securing the mounting
bracket to the wall studs)
2.3 Alternate Installation (Wallboard Installation) – What you will need (screws and anchors are not included in the
VersiCharge installation kit)
5 – #12 x 1-½ LG Phillips head Ø.375 head minimum, with 5 - #12 wall anchors (NOTE: wall anchors must be rated for 61 lbs.
for 1/2" dry wall ).
NOTE: plug-supplied
units (40A) will have
the Ferrite core
factory installed. Only
units to be hardwired
(48 A) will install the
Ferrite core.
1 – Ferrite Core
1 – Cable Holster
Tamper resistant 5/32" Allen
wrench (secure the charger)
VersiCharge™ AC Electric vehicle charging station
1 – Multi-use Connector
(This connector is used for both the ModBus and the
External Remote Control Interface Connector and supplied with commercial units only).
Admin Card
Admin Card
NOTE: Supplied with Commercial units only. For RFID setup, see RFID Setup in the complete
VersiCharge Installation and Operations Manual at: usa.siemens.com/versicharge.
2 – Admin Cards
1 – #8 x 2-1/2" Flat Head
Drywall Screw (for securing
the holster to the wall stud)
User Card
User Card
User Card
User Card
User Card
5 – User Cards
2 – #10-32 X 3/8", Tamper
Resistant, Pin-In Hex Socket
Button Head Cap Screws
(secure the charger)
6