Switching The Power On; Navigation Through The Menu; Controls - Viessmann Vitosolic 100 Installation And Service Instructions For Contractors

Switching the power ON

1. Check whether all electrical connections have been
correctly made.
2. Check that the high limit safety cut-out (if required)
is connected.
3. Switch ON the power; the solar control unit then
enters an initialising phase.
The solar control unit is now in automatic mode.

Navigation through the menu

Controls

KOL
B
Fig.9
OK key; to confirm your menu selection or setting
A
Symbols line
B
To terminate a new setting already begun (the
value reverts to its previous setting)
/ Cursor keys
For navigating through the menu
/ Cursor keys
To set a value
Flashing "SET" means that values can be
changed.
Calling up the menu
The symbol line on the display shows which keys
to use to make adjustments and call up informa-
tion.
Note
After approx. 4 min, the display changes to show the
collector temperature, if no further adjustments are
made.
°C
4. Check which type of solar circuit pump is connected
and set parameter "RPM" accordingly (see pages 7
and 14).
A
Commissioning
13