Checking The Switching Outputs - Viessmann VITOTROL 100 Installation And Service Instructions Manual

Commissioning
Commissioning the wireless receiver

Checking the switching outputs

1. Repeatedly press service button
less receiver (see fig. 10) until the required function
is activated: see the following table.
Function
Central heating
OFF
OFF
ON
ON
Note
If the receiver does not pick up any signal from the
Vitotrol 100 for more than 60 min, both switching out-
puts are enabled for heat demand.
14
(cont.)
on the wire- 2. To terminate the function:
B
press service button
or
automatically, if the switching output is closed via
the setting on the Vitotrol 100.
DHW heating
OFF
ON
OFF
ON
B .
LED LED
r
OFF OFF
OFF ON
ON OFF
ON ON