Table of Contents
Advertisement
CLEANING AND
MAINTENANCE
Continued
BULB REpLACEMENT
WARNING: The halogen light
bulbs in your unit can become
extremely hot. Allow at least 10
minutes between turning off the
heater and removing the light
bulbs to avoid accidental burns.
There are a total of 8 halogen light bulbs (type
GX6.35 rated 120 volts, 35 watts) in your unit.
• 2 bulbs provide illumination for the ember bed
beneath the log set
• 2 bulbs provide illumination for the flame
generation assembly
• 2 bulbs for backlighting
• 2 bulbs for replacement
WARNING: Do not install
replacement bulbs that exceed
specified maximum watts.
Your fireplace unit must be opened in order to
replace the light bulbs. To reduce the number of
times you need to open the unit, replace all bulbs
at the same time.
Ember Bed Bulbs
1. Carefully remove front panel (see steps 1
and 2 under Cleaning Firebox Compart-
ment, page 8).
2. From the bottom, gently pull forward and lift
up log set ember bed until front edge clears
the front of the unit (do not pull up on logs).
3. Remove spring clip. Hold socket and pull out
the old bulb.
4. Hold socket and push in new bulb (DO NOT
exceed wattage).
5. Replace spring clip onto bulb.
6. Repeat steps 3 through 5 for second bulb.
7. Gently push ember bed down until rear edge
is resting against rear ledge of unit.
8. Replace front panel.
Spring Clip
Figure 7 - Ember Bed Bulb Location
119624-01A
Bulbs
www.desatech.com
Flame Generation Bulbs
1. Carefully remove front panel (see steps 1
and 2 under Cleaning Firebox Compart-
ment, page 8).
2. From the bottom, gently pull forward and lift
up log set ember bed until front edge clears
the front of the unit (do not pull up on logs).
3. Remove left and right screws and brackets
that hold glass in place. These are located at
the bottom of glass panel (see Figure 8).
4. With gloves and safety glasses in place, lift up on
bottom of glass by placing the bracket removed
in step 3 under the edge of the glass. Gently push
upward and pull forward. Place glass on smooth,
soft surface to avoid breakage.
5. Locate flame generation cylindrical drum,
Figure 9.
6. Squeeze half of drum cylinder until it's top
edge clears the top drum track. Remove bot-
tom edge of cylinder drum from bottom drum
track. This will give you access to the light
bulbs. Note: Do not exert excessive pressure
on drum cylinder as this may cause damage.
Figure 8 - Glass and Bracket Location
Flame Cylinder Drum
Figure 9 - Flame Generation Cylinder
Glass
Glass
Bracket
Drum
9
Advertisement
Table of Contents
