Makita KP0810 Instruction Manual page 8

Hide thumbs Also See for KP0810:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Removing or installing planer blades
CAUTION:
Tighten the blade installation bolts carefully when
attaching the blades to the tool. A loose installation
bolt can be dangerous. Always check to see they
are tightened securely.
Handle the blades very carefully. Use gloves or
rags to protect your fingers or hands when
removing or installing the blades.
Use only the Makita wrench provided to remove or
install the blades. Failure to do so may result in
overtightening or insufficient tightening of the
installation bolts. This could cause an injury.
For tool with standard planer blades
Fig.4
Fig.5
Fig.6
To remove the blades on the drum, unscrew the
installation bolts with the socket wrench. The drum
cover comes off together with the blades.
To install the blades, first clean out all chips or foreign
matter adhering to the drum or blades. Use blades of
the
same
dimensions
oscillation/vibration will result, causing poor planing
action and, eventually, tool breakdown.
Place the blade on the gauge base so that the blade
edge is perfectly flush with the inside edge of the gauge
plate. Place the adjusting plate on the blade, then
simply press in the heel of the adjusting plate flush with
the back side of the gauge base and tighten two screws
on the adjusting plate. Now slip the heel of the adjusting
plate into the drum groove, then fit the drum cover on it.
Tighten all the installation bolts evenly and alternately
with the socket wrench.
For tool with mini planer blades
1.
Remove the existing blade, if the tool has been in
use, carefully clean the drum surfaces and the
drum cover. To remove the blades on the drum,
unscrew the three installation bolts with the
socket wrench. The drum cover comes off
together with the blades.
Fig.7
2.
To install the blades, loosely attach the adjusting
plate to the set plate with the pan head screws
and set the mini planer blade on the gauge base
so that the cutting edge of the blade is perfectly
flush with the inside flank of the gauge plate.
Fig.8
3.
Set the adjusting plate/set plate on the gauge
base so that the planer blade locating lugs on the
set plate rest in the mini planer blade groove,
then press in the heel of the adjusting plate flush
with the back side of the gauge base and tighten
the pan head screws.
and
weight,
or
drum
4.
It is important that the blade sits flush with the
inside flank of the gauge plate, the planer blade
locating lugs sit in the blade groove and the heel
of the adjusting plate is flush with the back side of
the gauge base. Check this alignment carefully to
ensure uniform cutting.
5.
Slip the heel of the adjusting plate into the groove
of the drum.
6.
Set the drum cover over the adjusting plate/set
plate and screw in the three hex flange head bolts
so that a gap exists between the drum and the
set plate to slide the mini planer blade into
position. The blade will be positioned by the
planer blade locating lugs on the set plate.
Fig.9
7.
The blade's lengthwise adjustment will need to be
manually positioned so that the blade ends are
clear and equidistant from the housing on one
side and the metal bracket on the other.
8.
Tighten the three hex flange head bolts (with the
socket wrench provided) and rotate the drum to
check clearances between the blade ends and
the tool body.
9.
Check the three hex flange head bolts for final
tightness.
10. Repeat procedures 1 - 9 for other blade.
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kp0810c

Table of Contents