Table of Contents
Advertisement
SPD User's Manual
Before you start the Telnet application, the user need to obtain the actual IP address for the system. The system
displays network connectivity information at system startup terminal when your workstation is connected to the
system's Local Master Serial Port. Please refer to "TCP/IP Network Configuration" section of this document for
information on how to setup the network parameters.
Once the network connection is established, at your workstation prompt, you need to enter:
telnet ip_addr
You need to set a Telnet session on your workstation to Local Echo Off mode.
Telnet session permits an anonymous user who may only to view the system settings and operate unreserved
power outlets and user serial console ports. Please refer to "User Privileges and Port Reservations" for further
information.
•
There are 8 Telnet session at most may be active at the same time.
•
A Telnet session remains active for 10 minutes if it is in idle state.
•
Telnet access methods can be enabled or disabled using the System Access Setup Menu.
•
To terminate an active Telnet session, use the command "exit" at the terminal.
Web Access
You need to obtain the system IP address before starting web access to the system. Please refer to the Telnet Ac-
cess section for methods to get the system IP address. You also need to make sure that web access is enabled, as
a default setting. If the access is not enabled, please refer to Section "Using Configuration Menu" to change the
setting. Start a Web browsing application program such as Window's Explorer and enter "http://ip_address"in the
address field.
You must have an account on the system in order to access the system via this method. Without a valid account,
you are only able to view the following web page and get a copy of the Help text message.
Xtreme Power Conversion Corporation
Telnet Session Startup Screen
Power Distribution Unit
Page 9
Advertisement
Table of Contents
