Table of Contents
Advertisement
SPD User's Manual
Power Distribution Unit
Baud Rate:
The system supports the following baud rates: 2400, 4800, 9600, 19200, 38400, 57600 and
115200. It is strongly recommended that Master port and a user serial port have the same data rate while exchang-
ing data between them so that data loss is eliminated. If you must run both ports using different baud rates, Flow
Control (hardware handshaking) should be enabled on all connected serial console ports.
Please also note that when Telnet access is used for exchanging data between the system's Ethernet interface port
and user communication equipment, without enabling flow control, you might experience data loss when data
exchange rate is high. This is because data flow from the system's Ethernet port is subject to the congestion condi-
tion of LAN traffic.
Data Bit:
Supports 7 or 8 bits.
Stop Bits:
Supports 1 or 2 bits.
Parity Bits:
Supports Even, Odd or None.
Flow Control:
Flow Control is hardware handshaking using CTS/RTS signals on the connectors. Please see Appendix A for infor-
mation about RS232 connector pin assignments.
Port Name:
Assign a name for the port. Always assigned to the name "Master".
Xtreme Power Conversion Corporation
Page 21
Advertisement
Table of Contents
