Installing/ Removing The Fitting - Safegate Group SL-HF-I Manual

Airfield Lighting
Manual
Ref: SL-HF-I; SL-HT-I
2.1

INSTALLING/ REMOVING THE FITTING

Install
(a) Open the box and verify that the
characteristics of the fitting correspond to
your design requirements (type, colour etc.).
(b) Control the label on the fitting for product
information.
(c) Carefully clean all contact surfaces on the
fitting and the base (and if necessary on the
adaptor ring).
(d) Place the O-ring gasket on the fitting.
(e) Check that the fitting corresponds to the
actual installation position (colour, direction).
(f) Connect the fitting connector(s) to the base
supply cable(s).
(g) Place the connector under the fitting and
install on the base.
(h) For an installation on bases use a torque
limiting box spanner of 16 mm, install and
tighten the two M10 lock nuts to a torque of
35 Nm (= 3.5 kg m). For other base
manufacturers refer to their specifications.
(i) After installation, check that each fitting
works properly.
Remove
(a) When removing the fitting, it is recommended to change the lock nuts each time
the fitting is dismounted.
(b) Remove the fitting from the base using two large flat blade screwdrivers.
(c) Disconnect the secondary supply connector.
(d) Remove the O-ring gasket. It is recommended to change the gasket each time the
fitting is removed from the base.
WARNING! WHEN A FITTING HAS BEEN REMOVED, THE BASE MUST
BE FITTED WITH A COVER DESIGN FOR THIS PURPOSE OR WITH A
SPARE LIGHT FIXTURE.
Page 6 of 16
Safegate Group
Date: September 2014
Version: 1.3
FIGURE 4 – INSTALLATION