Installation - Safegate Group SL-HF-I Manual

Airfield Lighting
Manual
Ref: SL-HF-I; SL-HT-I
2.

INSTALLATION

In this section you can find a description of the different steps for successful
installation of the fitting. Before you start, make sure you have read and understand
§1.1 Safety Instructions.
The SafeLED Heliport fitting can be installed in one of following:

a 8 inch shallow base, minimum height 100 mm with side or bottom entry for the
cable. The fitting is fixed with two M10 lock nuts

a 12 inch base with side or bottom entry. The fitting shall be installed together with
an AFL adapter ring 12"-8" with two M10 studs

an FAA L-868B deep base using adapter ring
The following tools are recommended for installation and removal of the fitting:

Box spanner (16mm)

Torque wrench (16mm)

Two big flat screwdrivers (for removal)

One brush or cloth
Note: Provided that the receiving base has been properly installed, no other tools are
required.
Typically, the installation steps refer to:
1. Installing/ removing the fitting
2. Electrical connections
Page 5 of 16
Safegate Group
Date: September 2014
Version: 1.3