Bluetooth® Management; Tones; Connecting The Reader To A Pc; Using Usb Interface - HomeAgain Universal Worldscan Reader Plus User Manual

3.7 BLUETOOTH
The UWSR+ is equipped with a Class 2
with the Bluetooth® Serial Port Profile (SPP).
Enable the Bluetooth
Using Bluetooth
Software User Guide"). By default, the Bluetooth module is DISABLED.
Bluetooth works on a premise that one end of the communication will be paired to the other one. A
®
host initiates communications and looks for other devices to connect. Smart phones and computers
usually establish the connection with readers which are connectable and discoverable.
Note 3 – Understanding the Bluetooth
Disabled
No icon
Note 4 – A single beep is emitted with a visual message when the Bluetooth
established. Three beeps are emitted with a visual message when the disconnection occurs.
Note 5 – If you are using a Smartphone or a PDA, an application is required (not supplied).

3.8 Tones

The scanner has distinct Beep tones for different functions: after start up, when scan button is pushed
or released, when microchip is found, or during low battery condition.

4 Connecting the reader to a PC

The device can connect to a personal computer (PC) in 2 ways: by a wired USB connection or by a
wireless Bluetooth

4.1 Using USB interface

The USB port allows the device to send and receive data via a USB connection.
To establish a USB connection, simply connect the reader to a PC with the USB cable.
3 Operating distance of communication is around 15 m (49 ft).
User Manual
management
®
3
feature by using the "Microchip Management Software" (refer to section
®
interface to pair, from Windows
®
Connectable mode
Blinking
Not connected
connection.
®
Install the Microchip Management Software available for download
at http://microchip.homeagain.com/
1
drivers for the reader. When reader is connected, Windows will
automatically find the driver and install the reader properly.
Remove the protective cap covering the reader's USB connector
(replace protective cap to guard the reader against foreign material
2
contamination once the USB cable is removed).
Install the USB cable by attaching it to UWSR+.
Bluetooth module to communicate. This device is compliant
®
and the document "Microchip Management
icon:
®
Fixed
Connected Not connected
Host mode
Blinking Fixed
Connected
connection is
®
in order to pre-install USB
7