Operation And Settings; Getting Started; Battery Handling Instructions - HomeAgain Universal Worldscan Reader Plus User Manual

3 Operation and settings

3.1 Getting Started

UWSR+ comes supplied with six AAA rechargeable NiMH batteries which must be fully charged prior
to use, as diagram below (step 1 through 3).
If preferred, six standard non-rechargeable AAA Alkaline
should be followed (step 2 and step 3 do not apply).

3.2 Battery handling instructions

Please read and follow the handling instructions for the batteries before its use. The batteries should
only be charged with the USB cable and wall adapter supplied with the reader. Improper use of
batteries may cause its capacity deterioration or cause heat, fire, rupture or damage. For best
performance of batteries, unit should be charged at least every three months, if reader is unused.
Caution
USE RECHARGEABLE BATTERIES WITH SAME CAPACITY AND DO NOT MIX RECHARGEABLE

AND STANDARD BATTERIES.
DO NOT ATTEMPT TO CHARGE STANDARD ALKALINE BATTERIES.

BATTERIES MUST BE CHARGED INDOORS ONLY, AT TEMPERATURE BETWEEN 32º F and 104° F.

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.

DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

Warning
Do not use the reader near water when connected to the AC/DC adapter.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
that produce heat.
Do not charge the battery pack from AC main sources during electrical storms or when unused for
long periods of time.
We recommend Duracell® or Energizer® alkaline batteries
1
1
Remove retention screw located on center of back of UWSR+. Place
batteries according to polarity indicators. Replace lid and screw.
2
Remove USB plug and attach cable in the UWSR+.
Plug the adaptor into power outlet. The battery level icon will flash while
3
charging and stop flashing when fully charged. A full charge will take
approximately 3 hours.
batteries can also be used and only step 1
1
4