3.3 Power on / off instructions
To turn the UWSR+ on, press and release the "SCAN" button once. During this start up time the reader
will display the screen below, beep once, and then display "READY".
Firmware version
Note 1 - Once activated, the reader will stay on for 2 minutes by default.
3.4 Reading an implanted microchip
3.4.1
Scanning and LOCATING AN IMPLANTED MICROCHIP
When searching implantable microchips, place the reader so it touches the animal as shown in
pictures.
Use the following scanning patterns to locate the microchip. Perform pattern 1 and 2 on Left, Top and
Right sides of animal's neck and shoulders, as microchip placement might vary per animal.
Keep scanner touching animal and scan slowly following patterns below:
To search for microchips, press and hold down the SCAN button. The reader will display "SEARCHING"
until a microchip is found or the scan button released.
If the microchip was not found (see message below), re-test the Scanner with the test chip and rescan
the animal, moving slower and varying angle of scans.
The following pictures show the result of a successful reading session:
Note 2 – If a microchip was found and the reader is connected via its USB interface or its Bluetooth
interface to a host computer, it will send the microchip number to the host computer.
User Manual
Welcome
V0.86.00
For Pets
Pattern 1
Pattern 2
SEARCHING...
®
5