Table of Contents
Advertisement
Setting the Pattern by Program Input
Input
Fig. 5 is used here as an example to explain label stitching.
(1) Set the required pattern number from A to H.
(2) Press the
input key to select input mode.
(3) Ensure that step "1" displays and stitch number "0" is flashing.
(Fig. 6)
If the stitch number is not flashing, press the
stitch number "0" starts flashing.
(4) Step 1 can be input even with the
method explained here does not use this key, and therefore start and end
backtacking are not performed.
(5) Setting step 1 (Backward stitching of 3 stitches at middle
speed without stopping)
(5.1) Press the setting value selection key ( 12 ) and set the
stitch number to "3".
(5.2) Press the
LED. (Middle speed when in output mode)
(5.3) Press the
next step without stopping.
(5.4) Press the
reverse stitching.
(5.5) Step 1 setting is now complete. Press the
"2". At this time, the number of stitches displayed is "0" and flashes.
(6)Setting step 2 (10 stitches at pedal speed, presser foot lifted and
stopped)
(6.1) Press the
keys ( 11 , 12 ) and set the stitch number to "10".
(6.2) Press the
after stopping.
(6.3) Step 2 setting is now complete. Press the
( 10 ) to change the displayed step to "3". At this time, the
number of stitches displayed is "0" and flashes.
(7) Set steps 3 to 5 in the same manner.
(8) Setting step 6 (13 stitches at pedal speed with automatic thread trimming followed by presser foot lifting)
(8.1) Press the
to "13".
(8.2) Press the
(8.3) Press the
(9) Program input is complete at the above step. Next, press the
automatically changes to "1" and output mode is selected.
Caution: Ensure to press the
Input patterns are not stored in the memory if the power is turned OFF with the
(input mode).
key ( 23 ) repeatedly until
start backtacking key, however, the
middle speed key ( 27 ) to turn ON the
continuous key ( 25 ) to proceed to the
reverse stitching key ( 24 ) to specify
setting value selection
presser foot up key to lift the presser foot
setting value selection keys ( 11 ,
trim key ( 31 ) to turn ON the LED and perform thread trimming.
presser foot up key to lift the presser foot after stopping.
key after input is complete.
Step5
1
8
Press keys to turn
ON the LED.
step key ( 10 ) to change the displayed step to
Press keys to turn
ON the LED.
step key
output key ( 20 ). The step
- 9 -
Step1
Step6
3
13
5
20
Step4
Fig. 5 Label stitching
Fig. 6 Step and stitch number
9
10
11
9
10
11
12 ) and set the stitch number
key still ON
Step2
10
5
Step3
display
12
12
Advertisement
Table of Contents
