Table of Contents
Advertisement
Continuous Backtacking
While watching pattern number display area
selection key 8 .
Press the
*
The
C, D) displays at the stitch number display area ( 2 , 3 , 4 , 5 ). While watching
these values, set the number of stitches using the setting value selection keys
( 9 , 10 , 11 , 12 ).
Press the
*
The
display area ( 2 , 3 , 4 , 5 ). While watching these values, set the number of times using the setting
value selection keys ( 9 , 10 , 11 , 12 ).
Press the
key and setting the number of stitches for fixed-stitch stitching is valid.
Notes 1. When forced full pedal heeling is performed during the pattern, end backtacking will be
performed.
2. The pattern and start backtacking cannot be changed when stopped during the pattern.
End backtacking type can be changed.
3. Change of the pattern, start and end backtacking have to be done after full pedal heeling.
.
Using the Trimming Key
Basically, thread trimming is performed when the LED in the upper left of the trimming key
illuminated. The operation, however, will differ depending on the condition. Please refer to the following for
further details.
1.
Standard lock
stitching
(manual stitching)
(continuous
backtacking)
Patterns 1 to 4
2.
Fixed-stitch stitching
(continuous
backtacking)
Patterns 1 to 4
3.
Patterns A to H
key ( 6 ) to set the number of stitches.
LED illuminates and the number of stitches (A, B,
key ( 7 ) to set the number of times the operation is performed.
LED illuminates and the number of times (N) displays at the stitch number
To trim the thread at the end of stitching (pedal heeling operation), press the
:
key to turn ON the LED in the upper left of the key.
To cancel thread trimming at the end of stitching (pedal heeling operation),
press the
key to turn OFF the LED in the upper left of the key. Thread
trimming will not be performed when the LED is not illuminated.
(This only applies when the sewing machine stops at the UP position after the
set end backtacking is performed.)
To stop the sewing machine after fixed-stitch stitching is complete (with the
:
pedal pressed down), press the
LED in the upper left of the key. When the LED is not illuminated, the machine
stops at the specified position (UP or DOWN) following the completion of
fixed-stitch stitching. Next, heel the pedal to perform the set end backtacking
and thread trimming.
To cancel thread trimming at the end of stitching at the corresponding step in
:
the program/teaching input mode, press the
the upper left of the key.
In the output mode, the sewing machine stops after stitching that step. (If the
pedal is fully heeled, the thread is trimmed, and the machine returns to step 1.)
The
key is disabled when in the output mode.
1 , select pattern 4 using pattern
key before stitching to turn OFF the
- 6 -
is
key to turn OFF the LED in
1
8
Advertisement
Table of Contents
