Table of Contents
Advertisement
17.2 Preparing the appliance for the
cleaning function
In order to achieve a good cleaning result, prepare the
appliance carefully.
ATTENTION!
Using oven cleaner on the self-cleaning surfaces dam-
ages the surfaces.
Do not use oven cleaner on the self-cleaning sur-
▶
faces. If oven cleaner does get onto these surfaces,
dab it off immediately using water and a sponge
cloth. Do not rub the surface and do not use abras-
ive cleaning aids.
Remove accessories and cookware from the cook-
1.
ing compartment.
Unhook the shelf supports and remove them from
2.
the cooking compartment.
→ "Shelf supports", Page 23
Use a detergent solution and a soft cloth to remove
3.
heavy soiling:
– From the cooking compartment floor
– From the inside of the appliance door
– From the glass cover for the oven light
This prevents stains that cannot be removed.
Remove any objects from the cooking compartment.
4.
The cooking compartment must be empty.
17.3 Setting the cleaning function
Ventilate the kitchen while the cleaning function is run-
ning.
WARNING ‒ Risk of burns!
The outside of the appliance gets very hot when the
cleaning function is in progress.
Never touch the appliance door.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
18 Shelf supports
To clean the rails and the cooking compartment, or to
replace the rails, you can remove these.
18.1 Detaching the shelf supports
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Lift the rail forwards slightly
1.
and detach it
.
Requirement: Prepare the appliance for the cleaning
function. → Page 23
Use the function selector to set EcoClean .
1.
a The display shows the duration. The duration of
one hour cannot be changed.
Turn the temperature selector.
2.
appears in the display.
a
a The cleaning function starts after a few seconds and
the time counts down.
a Once the cleaning function has ended, an audible
signal sounds and the display shows the duration
as zero.
Switch off the appliance.
3.
Wipe the appliance clean. → Page 23
4.
17.4 Wiping the appliance clean
following the cleaning function
Allow the appliance to cool down.
1.
Wipe the cooking compartment clean with a damp
2.
cloth.
Note: Marks may appear on the self-cleaning sur-
faces. Residues of sugar and albumin in the food
are not removed and remain on the surfaces. Red-
dish patches may be left over from salty food – the
spots are not rust. These spots are not harmful.
These marks do not impair the cleaning ability of
the self-cleaning surfaces.
3.
Attach the shelf supports.
→ "Shelf supports", Page 23
2.
Pull the whole rail to the front
18.2 Attaching the shelf supports
Notes
¡ The rails only fit on the right or left.
¡ For both pull-out rails, ensure that you can pull them
forwards and out.
Shelf supports en
and remove it.
23
Advertisement
Table of Contents
