Advertisement
Quick start guide
Before you start
1. Register on the Developer Community and
then download and install ModusToolbox™
software v2.3 (or later) with the Bluetooth®
SDK at
https://www.cypress.com/products/
modustoolbox.
2. Do the following to download and
install the 'Hello Sensor' code example.
This step will also install the 'Hello Client'
peer application required later.
a. In Eclipse IDE for ModusToolbox™
software, select File > New application.
This launches the project creator.
b. In the project creator, click
AIROC™ Bluetooth® BSPs.
c. Select the 'CYW920835M2EVB-01'
kit and click Next.
d. Click Create and then click Close.
Note: The kit is pre-programmed with the
'Hello Sensor' application.
3. Connect a USB cable between the PC and
CYW920835M2EVB-01 (J6) to power the kit.
Run the 'HelloClient' application
1. Locate the 'HelloClient' peer sample
application that complements the
'Hello Sensor' application at
...\mtw23\mtb_shared\wiced_btsdk\
tools\btsdk-peer-apps-ble\release-v3.1.0\
hello_sensor\Windows\HelloClient\
Release\x64.
2. Run the HelloClient executable and
select the HelloSensor device, which
appears as a device with the name 'Hello'.
3. When prompted, allow pairing from
the client to the Hello Sensor device.
4. In the HelloClient window, select Allow
Notifications next to the Hello Input
characteristic.
5. Press button SW3 on the evaluation kit.
Observe that the Value field shows the
Hello 1 message.
6. Press SW3 again, and observe that the Value
field is incremented.
ModusToolbox™ software
HelloClient application
Advertisement
