Xycom XVME 200 Manual page 24

XVME-200/290 Manual
December, 1987
2.5.2 Pl and P2 Connectors
Connectors PI and P2 are mounted at the rear edge of the board (see Figure
The pin connections for
address, data, and control signals necessary for the operation of VMEbus-defined
NEXP modules. (The signal definitions and pin-outs for the connector are found in
Appendix A of this manual.) The Pl connector is designed to mechanically interface
with a VMEbus defined Pl backplane.
2.5.3 P2 Connector
The P2 connector is a standard VMEbus P2 backplane connector with 96-pins (3
(The pin-outs for the connector P2 are found in Appendix A of this
rows).
The P2 connector is designed to interface with a VMEbus defined P2
manual.)
The P2 connector has been modified slightly for the XVME-290/l (see
backplane.
Table 2-7).
( a 96-pin, 3-row
Pl
XVME-290/l
2-12
connector) contains the standard
2-1).