Fuel Feeding - TOHATSU M40D2 Owner's Manual

40
ENGINE OPERATION
2
3
1. Rod snap
2. Control lever
3. Open side position
4. link rod
5. Advancer arm
ENOM00044-E

2. Fuel feeding

7
ENOW00029-1
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out if the fuel tank cap is opened
by using another procedure when internal
pressure of fuel tank is raised by heat from
sources such as sun light.
1. Fully open the air vent screw on the
fuel tank cap.
1. Air vent screw
2. Fuel tank cap
ENOF00652-B
WARNING
1
2
ENOF00027-B
2. Open the fuel tank cap slowly and
release internal pressure completely.
After that, close the fuel tank.
3. Connect the fuel connector to the
engine and fuel tank.
1
2
1. Fuel connector
2. Pull
3. Insert
1
1. Pull
2. Insert
4. Squeeze primer bulb until it becomes
stiff to feed fuel to carburetor. Point
the arrow mark upward when priming.
1
2
1. Engine side
2. Fuel tank side
3
ENOF01905-0
2
ENOF00861-A
ENOF00862-0