Maintenance; Storage; Cleaning - Omron HEM-7157T Instruction Manual

Display/Problem
Readings appear too high
or too low.
Any other communication
issue occurs.
Any other problem occurs.

4. Maintenance

4.1 Maintenance
To protect your monitor from damage, follow the directions below:
Changes or modifications not approved by the manufacturer will void the
user warranty.
Caution
DO NOT disassemble or attempt to repair this monitor or other
components. This may cause an inaccurate reading.

4.2 Storage

• Keep your monitor in the storage case when not in use.
1. Remove the arm cuff from the monitor.
Caution
To unplug the air plug, pull on the plastic air plug at the base of the
tube, not the tube itself.
2. Gently fold the air tube into the arm cuff. Note: Do not bend or
crease the air tube excessively.
3. Place your monitor and other components in the storage case.
• Store your monitor and other components in a clean, safe location.
• Do not store your monitor and other components:
• If your monitor and other components are wet.
• In locations exposed to extreme temperatures, humidity, direct
sunlight, dust or corrosive vapors such as bleach.
• In locations exposed to vibrations or shocks.
Possible Cause
Blood pressure varies constantly. Many factors including stress, time of day, and/or how you
apply the arm cuff, may affect your blood pressure. Review section 2 of instruction manual
Follow the instructions shown in the smart device, or visit the "Help" section in the "OMRON
connect" app for further help. If the problem still persists, contact your local OMRON
representative.
Press the [START/STOP] button to turn the monitor off, then press it again to take a measurement.
If the problem continues, remove all batteries and wait for 30 seconds. Then re-install batteries.
If the problem still persists, contact your local OMRON representative.
Solution

4.3 Cleaning

• Do not use any abrasive or volatile cleaners.
• Use a soft dry cloth or a soft cloth moistened with mild (neutral)
detergent to clean your monitor and arm cuff, and then wipe
them with a dry cloth.
• Do not wash or immerse your monitor and arm cuff or other
components in water.
• Do not use gasoline, thinners or similar solvents to clean your
monitor and arm cuff or other components.
4.4 Calibration and Service
• The accuracy of this blood pressure monitor has been carefully
tested and is designed for a long service life.
• It is generally recommended to have the unit inspected every two
years to ensure correct functioning and accuracy. Please consult
your authorised OMRON dealer or the OMRON Customer Service
at the address given on the packaging or attached literature.
.
EN
6