Carry hook
The carry hook is convenient for temporarily hooking
the tool. It can be installed on either side of the tool.
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow
(1) and raise it in the direction of the arrow (2).
2
1
► 1 . Hook
OPERATION
1
2
3
► 1 . Side blade 2. Side blade surface 3. Center blade
4. Workpiece
CAUTION:
•
Edges and chips of the workpiece are sharp.
Wear gloves. Otherwise it can cause injury.
1
1
4
Secure the workpiece firmly. Move the tool forward keep-
ing the side blades flush with the workpiece surface.
Adjusting shear blade
2
3
4
► 1 . Screws 2. Side blade L 3. Center blade 4. Side
blade R 5. Sleeve
Adjust the side blade L so that the curl of waste material
does not contact the cutting head or the workpiece. Use
the hex wrench to loosen the three screws which hold
the cutting head. Move the side blade L back and forth
to adjust it. Then tighten the three screws with the hex
wrench.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
•
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
Lubrication
2
3
4
► 1 . Screws 2. Side blade L 3. Center blade 4. Side
blade R 5. Lubricate
8 ENGLISH
1
5
1
5