Makita DJS130 Instruction Manual page 7

Removing cutting head
Use the hex wrench to loosen the three screws which
secure the cutting head. Pull the cutting head straight
out to remove it with turning it left and right alternately.
1
2
► 1 . Cutting head 2. Screws 3. Hex wrench
Removing shear blades
1
2
3
4
► 1 . Screws 2. Side blade L 3. Center blade 4. Side
blade R 5. Sleeve
Remove the three screws which hold the cutting head.
When removing the second screw, be careful not to fall
the sleeve. Then the blades can be removed easily.
When removing the blades, hold the blades and the
sleeve so that they do not fall from the cutting head.
Installing shear blades
2
3
4
► 1 . Cutting head 2. Sleeve 3. Side blade R 4. Center
blade 5. Side blade L 6. Screws
3
5
1
6
5
Install the sleeve and tighten the three screws after
inserting the center blade, side blade L & R into the
cutting head. In this process, the screw heads should
be protruding 2 - 3 mm from the cutting head surface.
If you will tighten the screws excessively, the cutting
head cannot be installed to the tool.
Installing cutting head
CAUTION:
• Secure the cutting head firmly. Otherwise it can
rotate during operation and can cause serious
injury.
1
2
► 1 . Cutting head 2. Screws 3. Hex wrench 4. Tighten
Insert the cutting head into the tool with turning it left
and right alternately. Then tighten the three screws with
the hex wrench.
Hex wrench storage
► 1 . Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
7 ENGLISH
3 4
1