Belling BFS54SCCG Instruction Manual page 25

INSTALLATION
Locating the cooker
This appliance must be installed by an authorised person in accordance with this instruction
manual, local electrical regulations, local water regulations, local health regulations, Building
Code of Australia and any other government authority.
Overheat clearances - (Measurement A)
The distance between the highest part of the hob of the cooking appliance should be higher
than 600mm for a range hood and higher than 750mm for an overhead exhaust fan.
Installation of the anti-tilt plate
• Determine position of cooker and anti-tilt plate.
• Securely fix the anti-tilt plate to the floor with appropriate
fasteners.
• Fasten the front edge of anti-tilt plate with the 2 screws.
Slide the cooker back into the anti-tilt plate so that rear
•
cover rests against the rear wall. Then check the height
and level of the cooker. If required, pull the cooker back
out and adjust the leveling feet as required.
• Connect Electricity supply/gas supply but do not turn on
until installation is completed.
Side clearances - (Measurements B & C)
Where B, measured from the periphery of the
nearest burner to any vertical combustible surface,
or vertical combustible surface covered with
toughened glass or sheet metal, is less than
200mm, the surface shall be protected to a height
of C, of not less than 150mm above the hob for
the full dimension (width or depth) of the cooking
surface area.
Additional requirements for freestanding
and elevated gas cooking appliances -
(Measurements D & E)
Where D, the distance from the periphery of the
nearest burner to a horizontal combustible surface
is less than 200mm, then E shall be 10mm or
more, or the horizontal surface shall be above
the trivet.
25