Belling BFS54SCCG Instruction Manual page 24

INSTALLATION
Installation Sequence
• Determine position of cooker and anti-tilt plate.
• Securely fix the anti-tilt plate to the floor with appropriate
fasteners.
• Fasten the front edge of anti-tilt plate with the 2 screws.
Slide the cooker back into the anti-tilt plate so that rear
•
cover rests against the rear wall. Then check the height
and level of the cooker. If required, pull the cooker back
out and adjust the leveling feet as required.
•
Connect Electricity supply/gas supply but do not turn on
until installation is completed
• In addition to the anti-tilt plate, the safety chains on the rear of the cooker must be installed.
is NOT a solid surface.
The safety chains should be as short as practically possible to avoid the cooker tilting forward.
• Fasten hook (1) by using a proper peg to the kitchen wall (5) and connect safety chain (3) to
the hook via the locking mechanism (2).
1 Safety chain (supplied and mounted to oven)
2 Stability hook
Warning for installer
Only a qualified person in compliance with the instructions provided must install the
appliance. Manufacturer declines all responsibility for improper installation, which may harm
persons and animals and damage property.
Important: The power supply to the appliance must be cut off before any
adjustments or maintenance work is done on it; - Air duct is supposed to use in
Ventilation.
.
1
4 Rear of cooker
5 Kitchen wall
24
2