Belling BFS54SCCG Instruction Manual page 23

INSTALLATION
Installing cooker - power connections (cont)
Warning: Connect the power cord must be in accordance with the instructions
listed in the table below
Connection mode
1N~
2N~
3N~
Connecting the supply cable to the mains
Install an approved circuit breaker with a minimum contact opening of 3 mm, between the
appliance and the mains fuse box .The circuit breaker should be sized according to the load
and should comply with current regulations (the earth wire should not be interrupted by the
circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than
50˚C with respect to the room temperature, anywhere along its length. Before switching fuse
ON in meter-box check:
• Earth continuity. The electrical safety of this appliance can only be guaranteed if the cooker is
correctly installed and earthed, in compliance with regulations on electrical installations.
• The electrical capacity of the system and sockets will support the maximum power of the
appliance, as indicated on the data plate.
• Go to section "Installing your new cooker".
Unpacking and installation Instructions for Installer
Unpacking
• Please check the product and make sure that there is no damage.
• Read the relevant Installation Sections of this Manual. Ensure understanding.
• Confirm that product is compatible with available electrical/gas supply. Ensure proposed
installation position does not conflict with Installation Sections.
• Check the attachment packing in good condition, complete accessories.
• Use screw driver to remove two fixed Anti-tilt plate screws and plate.
Locating the cooker
Study the diagrams following to be sure of the dimensions required to locate the cooker safely.
Make sure that the top of the cooker is at least 10mm higher than the level of the bench tops.
The appliance has been designed to fit in a 550mm wide gap in kitchen cabinets. The cooker
may also be installed at the end of a line of benches or with a free space on either side.
Wire cross-sectional area( mm
L1 L2
Min 4 –
Min 2.5 Min 2.5
Min 1.5 Min 2.5
23
)
2
L3 N
– Min 4
– Min 4
Min 2.5 Min 4
E
Min 4
Min 4
Min 4