GE Monogram ZV750 Technical Data Sheet page 2

IMPORTANT: High and Low voltage wires are routed separately.
Reinstall wires as shipped.
* Purpose is to
isolate the high-
voltage (120V)
Main Power Board
signals to prevent
electrical noise
issues.
– 120V Line input
– Filter switch harness
harness – Lamp harness
(both harnesses)
– User interface
harness – Blower motor
– Blower capacitor harness
harness
Junction box
Capacitor
CONTROl PCb
This PCB has the AC to DC power supply, microprocessor and fan
relays and is located in the control housing in the chimney area.
Pub. No. 31-14783
TO REMOVE ThE blOwER
Remove one screw on each side of the rear grease filter frame.
Lift off the frame.
Remove
screw
Disconnect the motor
ground wire. Unplug
the wire connector.
Remove 4 screws holding the blower in place.
PCB
NOTE: A security cable prevents the blower assembly from falling,
Blower
ground
but it is best to support the blower while removing the screws. To
wire
release the security cable, remove one screw. Replace the blower
by reversing these steps.
TO REMOVE ANd REPlACE duCT TRANSITION
wITh dAMPER
Push ductwork up and away from the top of the hood. Remove
one screw on each side of the transition and replace. Be sure to
reconnect the ductwork over the outlet and seal with duct tape.
NOTE: If the hood is installed for recirculating operation, the metal
damper flaps on top of the hood exhaust outlet may be removed.
Do not remove the duct transition. The damper is not required for
this recirculating operation.
• T E C H N I C A L D A T A S H E E T •
POWER MUST BE DISCONNECTED BEFORE SERVICING THE APPLIANCE
Remove
screw
WARNING