Table of Contents
Advertisement
Programming
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset, press
M
N, then press M
– To answer the call with the base unit, press
*1
M N 3 times.
*1 If M N is pressed, press M N 2 times.
n When monitoring from an outside line:
Answer the call.
If you want to respond from the monitoring
phone, press #1 using tone dialling.
You can turn off the baby monitor feature by
pressing #0.
Note:
R The unit disconnects the call automatically
after 2 minutes.
Other programming
Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customise the name of
each handset ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between handsets.
To display the handset name in standby mode,
turn on the handset name display feature
(page 36).
Handset
1
M
N#104
2
Enter the desired name (10 characters max.).
3
MOKN a M
N
Displaying the handset name
You can select whether or not the handset name
is displayed in standby mode. The default setting
is "Off".
Handset
1
M
N#105
2
MbN: Select the desired setting. a MOKN a
M
N
36
KX-TGF310_320BX_UE_0706_ver002.pdf 36
Storing an area code to be deleted
automatically
In some situations, phone numbers stored
automatically in the caller list (page 39) will
N.
include area codes. If you do not want to dial the
area code when making calls from the caller list,
you can store the area code which you want the
unit to delete automatically.
Example: You have stored the area code "123". If
you make a call from the caller list to the phone
number "123-456-7890", the unit dials "456-7890".
Handset / Base unit
1
2
Call restriction
You can restrict selected units from dialling certain
numbers. You can assign up to 6 phone numbers
to be restricted, and select which units are to be
restricted. Storing area codes here prevents the
restricted units from dialling any phone number in
that area code.
Handset / Base unit
1
2
3
4
5
6
7
M
N#255
Enter an area code (5 digits max.). a MOKN
a M
N
M
N#256
Enter the base unit PIN (default: "0000").
R If you forget your PIN, contact an authorised
service centre.
MbN: Select the desired units to be restricted.
a M N
R " " is displayed next to the selected
numbers.
R To cancel the selected unit: MbN: Select the
unit. a Press M N again. " " disappears.
MOKN
Select a memory location by pressing 1 to
6. a MOKN
Enter the phone number or area code to be
restricted (8 digits max.). a MOKN
Proceed with the operation for your unit.
Handset: M
N
Base unit: M
N
7/29/2015 11:36:01 AM
Advertisement
Table of Contents
