Table of Contents
Advertisement
Programming
4
Enter the desired hour and minute you wish to
end this feature. a MOKN
5
Proceed with the operation for your unit.
Handset: M
N
Base unit: M
N
Changing the start and end time
Handset / Base unit
1
M
N#237
2
Continue from step 3, "Turning do not disturb
mode on/off", page 33.
Setting the ring delay
This setting allows the handset and/or base unit to
ring during do not disturb mode if the caller waits
long enough. After the selected amount of time
passes, the unit rings. If you select "No
Ringing", the unit never rings during do not
disturb mode.
Handset / Base unit
1
M
N#239
2
MbN: Select the desired setting. a MOKN
3
Proceed with the operation for your unit.
Handset: M
N
Base unit: M
N
Note:
R When the answering system answers the call,
this feature does not work. (KX-TGF320 series:
page 3)
Selecting categories to bypass do not disturb
mode
Handset / Base unit
1
M
N#241
2
MbN: Select the desired category. a M N
R " " is displayed next to the selected
category numbers.
R To cancel the selected category: MbN: Select
the category. a Press M N again. " "
disappears.
3
MOKN
4
Proceed with the operation for your unit.
Handset: M
N
Base unit: M
N
34
KX-TGF310_320BX_UE_0706_ver002.pdf 34
Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing you to
easily monitor from different areas of the house or
place. The monitored handset (placed in a baby's
room, for example) will automatically call the
monitoring handset, base unit, or the phone
number stored when it detects sound.
Important:
R You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For example,
test its sensitivity. Check the connection if you
are diverting the baby monitor to an outside line.
R This feature should not be used as a substitute
for a medical or caregiver's supervision. It is the
caregiver's responsibility to stay close enough
to handle any eventuality.
Note:
R If the unit is connected to a PBX system, you
cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset on
the charger.
R The monitored handset never rings while it is
being monitored.
If the base unit is placed near the monitored
handset, turn off the base unit ringer volume
(page 29).
Setting the baby monitor
Perform the setting operation with the handset to
be monitored (for example, the handset placed in
a baby's room).
To monitor with a unit
The internal baby monitor feature is available:
– between handsets
– between a handset and the base unit
Handset
1
M
N#268
2
MbN: "On" a MOKN
3
MbN: Select the desired unit's number to
monitor with. a MOKN
R "Baby Monitor" will be displayed.
7/29/2015 11:36:01 AM
Advertisement
Table of Contents
