Table of Contents
Advertisement
NOTE:
•
Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
•
The light is provided with anti excessive dis-
charge circuit. When the lamp does not light up
even after the light switch is turned on, there is
likely to be battery power drop. Try to charge the
battery cartridge.
•
Keep the lamp switch in "off" position while not
in need of the light.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing the bit
Use only the bit shown in the figure. Do not use any
other bit.
1
2
► 1. Bit 2. Sleeve
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
•
•
Ring
► 1. Bracket 2. Ring 3. Screws
The hook is convenient for hanging the tool with hoist.
First, place the rope through the ring. Then hang the
tool up to the air with hoist.
11.2 mm
sure that the bracket and ring are secured and not
damaged.
Hook
that it is screwed firmly.
► 1. Groove 2. Screw 3. Hook
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
7 ENGLISH
If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
1
3
CAUTION:
Before using the ring, always make
CAUTION:
After installing the hook, make sure
1
2
2
3
Advertisement
Table of Contents
