.
The configuration parameters used in the examples outlined in this
document are for instructional purposes only. Please replace all
underlined entries (
your application.
C
ONFIGURE THE
The following steps create an IP address and subnet mask for the virtual interface vlan 1. If you
are not sure what IP address to assign, please contact your network administrator.
1.
At the # prompt, enter config terminal.
2.
At the (config)# prompt, enter interface vlan 1 to access the configuration parameters for
the virtual LAN (VLAN) interface.
3.
Enter ip address 10.26.12.12 255.255.255.0 to assign an IP address to the VLAN interface
using a 24-bit subnet mask.
4.
Enter no shutdown to activate the virtual interface to pass data.
5.
Enter exit to return to the Global Configuration mode.
Depending on your configuration, you may need to set a default gateway
as well using the (config)#ip default gateway command. If IP routing is
enabled on the unit, do NOT set a default gateway.
This note does not apply to the NetVanta 1224R PoE or 1224STR PoE
units with integrated routers.
E
T
NABLE
ELNET
The following steps create a password of adtran for Telnet access. By default, Telnet access is
enabled with a password of password.
1.
Verify that the prompt of your unit displays (config)#.
2.
Enter line telnet 0 4 to change the configuration parameters for the Telnet sessions.
3.
Enter login to initiate Telnet access.
4.
Enter password adtran to change the login password for the Telnet sessions.
5.
Enter exit to return to the Global Configuration mode.
6.
Verify that the prompt of your unit displays (config)#.
7.
Enter do write memory to save the current configuration.
For information on installing the VPN Accelerator Card, please refer to
the NetVanta 1000 Series Hardware Installation Guide on the
ADTRAN OS System Documentation CD included in your switch
shipment.
2
example
U
'
IP A
NIT
S
DDRESS
A
CCESS
Copyright © 2008 ADTRAN, Inc. All Rights Reserved.
) with your specific parameters to configure
Need help?
Do you have a question about the NETVANTA 1224 POWER OVER ETHERNET Series and is the answer not in the manual?