Setup; Setup - Decoder Card - Wavecom W40PC Manual

If enabled each message raising an alarm will be saved in another text file (*.sms) anywhere
on the network. This function allows the message to be forwarded via SMS (Short Message
Service). This requires a third party product.
Please note:
The AlarmMonitor requires DCOM to have been correctly installed. For WINDOWS 95,
DCOM must be installed before installing the decoder software. For WINDOWS NT4, this
requires Service Pack 3 or later. If you have removed DCOM from your system, you will have
to reinstall it before using the decoder.

Setup

The Setup menu is used to configure the hardware, and to customize the AlarmMonitor display
to your favorite font size and color.
Connect to any decoder on your network.
All settings are automatically saved. The AlarmMonitor will automatically use these settings
the next time it is started.
Exception:
The computer name and the card number will be overwritten if you run the AlarmMonitor
directly from the WAVECOM software. It will have the same settings as the WAVECOM
software.
Setup – Decoder Card
If you plan to connect to a card installed in a PC other than the one on which you have
installed AlarmMonitor, the ServerControl or the WAVECOM software must be running on
that PC.
Connect the AlarmMonitor to any WAVECOM card located in any computer on your local
network. If you do not connect to a card located in your local PC, enter the name of the remote
computer that contains at least one WAVECOM card. Select the address of the card.
Please
Connecting to a decoder card on the network may take up to two minutes! The wait cursor will
appear while the connection is being made.
WAVECOM Decoders v6.15 W40PC, W41PC, W51PC
Note:
AlarmMonitor • 219