3.5-Inch Hard Drive; Removing The 3.5-Inch Hard-Drive Assembly - Dell OptiPlex 3090 Small Form Factor Service Manual

Steps
1. Place the tabs on the right side of the hard-drive bracket onto the holders on the chassis and push the left side of the
bracket down until it clicks into place.
NOTE: Use the arrows seen on the bracket as guides to identify the tabs on the tray.
2. Connect the hard-drive data and power cables to the connectors on the hard drive.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in

3.5-inch hard drive

Removing the 3.5-inch hard-drive assembly

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
20 Removing and installing components
After working inside your
before working inside your
computer.
computer.