Cadillac XT4 Owner's Manual page 83

82 SEATS AND RESTRAINTS
Warning (Continued)
airbag could inflate even though
the airbag on-off switch is
turned off.
To help avoid injury to yourself or
others, have the vehicle serviced
right away. See Airbag Readiness
Light 0 104 for more information,
including important safety
information.
If the child restraint uses a top tether,
see ISOFIX Child Restraint Systems
0 77 for top tether anchor locations.
Do not secure a child restraint in a
position without a top tether anchor if
a national or local law requires that
the top tether must be anchored, or if
the instructions that come with the
child restraint say that the top tether
must be anchored.
When using the lap-shoulder belt to
secure the child restraint in this
position, follow the instructions that
came with the child restraint and the
following instructions:
1. Move the seat as far back as it will
go before securing the
forward-facing child restraint. Move
the seat upward or the backrest to
an upright position, if needed, to
get a tight installation of the child
restraint.
The push button used to release
the catch plate must be visible and
not obscured by the child restraint.
There must not be direct contact
between the child restraint and the
push button.
When the airbag off switch has
turned off the front outboard
passenger frontal airbag, the off
indicator in the airbag off light
should illuminate and remain
illuminated when you start the
vehicle. See Airbag On-Off Light
0 105.
2. Put the child restraint on the seat.
3. Pick up the latch plate, and run the
lap and shoulder portions of the
vehicle seat belt through or around
the child restraint. The child
restraint instructions will show
you how.
4. Push the latch plate into the buckle
until it clicks.
Position the release button on the
buckle, away from the child
restraint, so that the seat belt can
be quickly unbuckled if necessary.