Cadillac XT4 Owner's Manual page 341

340 VEHICLE CARE
3. Place the compressor on the
ground near the flat tyre.
Make sure the tyre valve stem is
positioned close to the ground so
the hose will reach it.
4. Remove the valve stem cap from
the flat tyre by turning it
anticlockwise.
5. Attach the air only hose (10) to the
tyre valve stem by turning it
clockwise until tight.
6. Plug the power plug (9) into the
accessory power outlet in the
vehicle. Unplug all items from
other accessory power outlets. See
Power Sockets 0 95.
If the vehicle has an accessory
power outlet, do not use the
cigarette lighter.
If the vehicle only has a cigarette
lighter, use the cigarette lighter.
Do not pinch the power plug cord
in the door or window.
7. Start the vehicle. The vehicle must
be running while using the air
compressor.
8. Press the on/off button (5) to turn
the tyre sealant and compressor
kit on.
The compressor will inflate the tyre
with air only.
9. Inflate the tyre to the
recommended inflation pressure
using the pressure gauge (8). The
recommended inflation pressure
can be found on the Tyre and
Loading Information label. See Tyre
Pressure 0 321.
The pressure gauge (8) may read
higher than the actual tyre
pressure while the compressor is
on. Turn the compressor off to get
an accurate pressure reading. The
compressor may be turned on/off
until the correct pressure is
reached.
Caution
If the recommended pressure
cannot be reached after
approximately 25 minutes, the
vehicle should not be driven farther.
The tyre is too severely damaged
and the tyre sealant and
Caution (Continued)
compressor kit cannot inflate the
tyre. Remove the power plug from
the accessory power outlet and
unscrew the inflating hose from the
tyre valve.
10. Press the on/off button (5) to turn
the tyre sealant and compressor
kit off.
Be careful while handling the
compressor as it could be warm
after usage.
11. Unplug the power plug (9) from the
accessory power outlet in the
vehicle.
12. Turn the air only hose (10)
anticlockwise to remove it from the
tyre valve stem.
13. Replace the tyre valve stem cap.
14. Return the air only hose (10) and
power plug (9) back to their
original storage location.
15. Return the equipment to its
original storage location in the
vehicle.