Stihl RMA 2 RP Instruction Manual page 56

Fault:
Poor cut, lawn turning yellow
Possible cause:
– Mowing blade is blunt or worn,
– Rate of feed is too high in relation to the
cutting height
Remedy:
– Re-sharpen or replace mowing blade
( 13.8)
– Reduce rate of feed and/or select
correct cutting height (
Fault:
Problems switching machine on or
deteriorating motor power.
Possible cause:
– Battery discharged
– Mowing grass that is too long or too wet
– Mower housing is blocked
– Mowing blades are blunt or worn
Remedy:
– Recharge battery ( 8.4)
– Adapt cutting height and mowing speed
to mowing conditions (
– Clean mower housing (
– Re-sharpen or replace mowing blade
( 13.8)
Fault:
Operating time too short
Possible cause:
– Battery not fully charged
– RMA 2 RP: No battery or discharged
battery inserted in battery
compartment 2
– Mowing grass which is too long or too
wet
– Mower housing is blocked
– Mowing blades are blunt or worn
54
– Battery has exceeded service life
Remedy:
– Charge battery (
– RMA 2 RP: Insert charged battery in
battery compartment 2
– Adapt cutting height and mowing speed
to mowing conditions (
– Clean mower housing (
– Re-sharpen or replace mowing blade
( 13.8)
– Replace battery ( )
9.4)
Fault:
Battery gets stuck when inserting into
battery compartment
Possible cause:
– Guides or electric contacts in battery
compartment dirty
Remedy:
– Clean guides and/or electric contacts in
battery compartment (
Fault:
Battery is not charged although the green
9.4) LED on the charger illuminates green
13.2)
Possible cause:
– Battery too cold or overheated (one red
LED illuminates on battery)
Remedy:
– Warm up or cool down the battery
( 8.4). Store the charger in a closed,
dry place at a temperature of between
+5°C and +40°C.
Fault:
Charging fails to start after inserting
battery into charger
Possible cause:
– Battery too cold/too warm – 1 LED
illuminates red on battery
– No electrical contact between charger
– Charger power supply faulty
8.2)
Remedy:
– Leave battery inserted in charger
9.4)
13.2)
– Remove and re-insert battery (
– Connect charger to mains (
– Check mains power supply
– Check charger, replace if necessary
Fault:
Battery is not charged, no LED illuminates
Possible cause:
– No electrical contact between charger
– Charger power supply faulty
13.2) Remedy:
– Remove battery from battery
– Connect charger to the mains (
– Check mains power supply
– Check charger, replace if necessary
Fault:
LED on charger flashes red
Possible cause:
– No electrical contact between charger
– Battery defective (4 LEDs on the
– Charger defective
Remedy:
– Remove battery from battery
– Check battery, replace if necessary ( )
and battery
Charging starts automatically as soon
as permissible temperature range is
reached.
( )
and battery
compartment and reinsert (
( )
and battery
battery flash red for approx. 5 seconds)
compartment and reinsert (
0478 131 9939 C - EN
8.2)
8.3)
8.2)
8.3)
8.2)