Installing The Server Into A Rack - IBM S824L Installing

E
C
Back
D
Figure 5. Attaching the rails
Remember: If your rack has square mounting holes, use the larger rail pins that are provided
with the rack installation kit.
c. Extend the left rail and insert the rail pins (D) into the two lowest mounting holes that are marked
on the rack. Rotate up the front clamp (C) to secure the rail in place.
4. Move to the rear of the rack, and complete the following steps:
a. Extend the right rail, and insert the rail pins (D) into the two lowest mounting holes that are
marked on the rack. Rotate up the back clamp (C) to secure the rail in place.
b. Extend the left rail and insert the rail pins (D) into the two lowest mounting holes that are marked
on the rack. Rotate up the back clamp (C) to secure the rail in place.
c. Use two M5 screws (E), one below each rail pin (D) to secure the left rail to the back of the rack.
d. Use two M5 screws (E), one below each rail pin (D) to secure the right rail to the back of the rack.
5. Move to the front of the rack and complete the following steps:
a. Use one M5 screw (E) below the lower rail pin (D) to secure the left rail to the front of the rack.
b. Use one M5 screw (E), below the lower rail pin (D) to secure the right rail to the front of the rack.

Installing the server into a rack

Learn how to install the system into the rack.
CAUTION:
This system requires three people to install the system into the rack.
6
Power Systems: Installing the IBM Power System S824L (8247-42L)
D
E
C
Front