Replacing The Dust Bag, S-Bag; Replacing The Motor Filter And Exhaust Filter - Electrolux Classic Silence Instruction Book

Table of Contents

Advertisement

1
4
6
9
2 1
28
A
B
2
5a
7
10
24 h
3 1
English
REPLACING THE DUST BAG, S-bag®
1
The dust bag, s-bag® must be replaced latest when
the indicator window is completely red. Read with the
nozzle lifted up.
Open the dust compartment cover.
2
Lift out the s-bag® holder.
3
3
4
Pull the cardboard to remove the s-bag® from the insert.
This automatically seals the s-bag® and prevents dust
leaking out.
5 a
Insert a new s-bag® by pushing the cardboard right into
the end of the groove in the insert
5 b
Place the dust bag holder back into the dust
compartment and close the lid.
Always change the s-bag® when the indicator signal is
illuminated even if the s-bag® is not full (it may be blocked) and
after using carpet cleaning powder. Use only Electrolux original
5b
synthetic s-bag®. www.s-bag.com
6-11 Replacing the motor filter (Ref No. EF 54) Should be
done with every 5th replacement of the s-bag® dust bag.
Never use the vacuum cleaner without a filter.
Cleaning /replacing the exhaust filter:
Replace (or wash) the exhaust filter every year.
There are two types of exhaust filters:
• Micro filter (Ref No. EF17 this type of filter can not be
washed and must be replaced with a new one.)
• Washable (Ref No. EFS 1W / EFH 12W)
8
12 To replace the exhaust filter, open the exhaust
filter lid by pulling the back edge upwards.
Replace the filter.
14 Close the lid inserting the front hooks into the
rails. Push the lid forward and press down in the
centre until both sides click in.
Cleaning the Washable Filter*
11
If you have a Washable exhaust filter*,
wash the filter once a year. If the filter is damaged,
replace it with a new filter.
13 To clean the Washable filter*, rinse the
inside (dirty side) in lukewarm tap water. Tap
the filter frame to remove the water. Repeat the
process four times. Let dry thoroughly and then
reinsert into the cleaner as above.
Note: Do not use cleaning agents and avoid touching the
filter surface. Let the filter dry completely before putting
back!
14
* Certain models only.

Advertisement

Table of Contents
loading

Table of Contents