Caring Fo R Your Ir On A Ft Er U S E; Turning Off Your Iron; Cleaning The Soleplate; Using The Self-Cleaning Feature - Oster GCSTPM7001 Instruction Manual

CARING FO R YOUR IR ON A FT ER U S E

1. Turn the fabric selector dial until the light turns off. Unplug the iron from the power
source.
WARNING: NEVER yank the power cord when unplugging the Iron. This can
damage the cord.
Clean the soleplate if starch or other residue accumulates.
To clean the soleplate:
1. Allow the iron to cool and then wipe it with a soft, damp cloth.
WARNING: DO NOT use abrasive cleansers, scouring pads or vinegar to clean the
soleplate. This will damage the finish.
2. Run the iron over an all-cotton cloth to remove any residue.

USING THE SELF-CLEANING FEATURE

You should use the Self-Cleaning feature to maintain the optimal performance of
your iron. The Self Cleaning feature will clean the water reservoir and steam vents of
accumulated minerals, dust and lint.
To use the Self-Cleaning feature:
1. Move the Steam Dial back and forth several times to remove debris and minerals
from the steam valve. This keeps water flowing into the steam chamber.
2. Fill the water reservoir with tap water to the "MAX" line.
3. Plug in the iron and move the fabric select dial to linen position "Lin", and allow the
iron to heat until the wait/ready light turns green.
4. Unplug the iron.
5. Hold the iron over a sink in a horizontal position.
WARNING: Be careful not to touch the iron's hot surfaces.
6. Press the Self-Clean button and hold. Water will begin dripping from the steam vents.
Slowly rock the iron side-to-side and front to back for 30 seconds. When rocking the
iron, dip the nose of the iron slightly below the rear to make certain the water
circulates completely.
7. Turn the iron upside down and allow the remaining water to flow out of the fill hole.
8. Dry the soleplate with a towel.
9. Plug in the iron and turn the Fabric Select Dial to the linen position "Lin". Let the iron
heat until the wait light turns green and dry out the iron completely.
10. Turn the fabric select dial to the off position "O". The light will go out, indicating that
the iron has turned itself off. Unplug the iron and allow it to cool before storing.

TURNING OFF YOUR IRON

CLEANING THE SOLEPLATE

English - 10