Oster GCSTPM7001 Instruction Manual page 5

SELECTING FABRIC SETTINGS
To select a fabric setting, turn the Fabric Select Dial to the desired fabric selection.
The wait light will glow red while the iron heats up. The light will then change to green
indicating that the iron is ready to be used.
Dry Ironing
1. Make sure the Steam Dial is turned to the closed position " ".
2. Plug the cord into the appropriate outlet.
3. Turn the Fabric Select Dial to the fabric setting you desire
(Silk "Seda" or Synthetics "Sintet").
Allow the iron to heat for 2 minutes. While the iron is heating,
make sure it is sitting on its heel rest on a stable, protected
surface.
NOTE: While the Steam Dial is turned to the closed position "
",
you may still use the Shot of Steam or Spray Mist features. Please
make sure the water reservoir is 1/4 full of water.
TIP: Refer to the "Ironing Guide" for the recommended setting for your fabric.
Steam Ironing
1. Follow the instructions for "Filling With Water".
2. Plug the cord into the outlet. The power indicator light will
illuminate.
3. Turn the Fabric Select Dial to the steam ironing fabric setting you
desire (Linen "Lin", Cotton "Algod", Wool "Lana" or Silk "Seda")
and allow iron to heat for 2 minutes. While the iron is heating,
make sure it is sitting on its heel rest on a stable, protected
surface.
TIP: Refer to the "Ironing Guide" for the recommended setting for
your fabric.
4. After the iron has heated (2 minutes), turn the steam dial to the desired steam setting.
IMPORTANT: When not ironing, always set the Steam Dial to closed position "
" and
the Fabric Select Dial to off position "O".
English - 4