Steam Ironing; Caring For Your Iron; Self-Cleaning Function - Oster 4420-449 Instruction Manual

STEAM IRONING

Plug in the Iron after filling the water tank, set the adjustable steam control switch to " "
(light-steam) or " " (heavy-steam) for model 4420 / or to "1-2-3" steam level positions for
model 4415, according to the desired temperature. Place the iron in a vertical position, after
the temperature indicator light has turned off.
SHOT OF STEAM FUNCTION
Make sure that the tank has been filled with water. The shot of steam button " "/" " produces
an extra steam jet. This helps fix pleats and remove difficult wrinkles. This function will
operate only during steam or in dry, if the temperature control has been set within the range
of cotton and linen.
NOTE: If the temperature is very low, water may come out from the soleplate. Allow 5
seconds between each time you use steam burst function to prevent watermarks. It may be
necessary to press the shot of steam button several times for steam to come out.

CARING FOR YOUR IRON

SELF-CLEANING FUNCTION

First, fill the iron with water and plug it into the outlet. Turn fabric select dial to position "max".
As the power indicator light goes out, pull out the plug and press the Self-Clean Button. The hot
water and steam will flow out from the soleplate vents, the residues will flow out with the water.
Plug unit back into the appropriate electrical outlet, as the indicator light goes out, press shot of
steam button for a few seconds and the remaining water will turn into steam and come out.
CARE AND CLEANING OF THE NON-STICK COATING
Never iron over zippers, pins, snaps, buttons, or metal rivets as these may scratch the
•
soleplate.
To clean the soleplate of occasional build-up, wipe iron once it is totally cool with a soft
•
cloth. Do not use abrasive cleaners or metal scouring pads.
CLEANING AND STORING YOUR IRON
Turn the fabric select dial to the Off position and the adjustable steam control switch to the
•
no steam position " " (Model 4420 only)/ to the "0" position (Model 4415 only), then
unplug the iron and let cool.
To empty water from the iron, slowly tilt the pointed end of the iron over the sink. The water
•
will run out of the water fill opening.
Wrap the cord loosely around the cool iron and store it upright resting on the heel rest.
•
Wrapping the cord too tightly can damage the cord. Do not store the Iron lying flat on the
soleplate, as any small amount of residue or moisture may cause the soleplate to discolor.
4415_4420-449_15EM1.indd 4
All manuals and user guides at all-guides.com
4
9/11/15 15:25