Enabling Auditory Feedback; Choosing And Adjusting A Prompt Voice - Prio mini User Manual

Enabling Auditory Feedback

You can include audio feedback in scans. To enable auditory prompts, choose Menu > Settings >
Auditory Scan. When you are scanning, simply activate your switch. To retrieve a message, activate the
switch again after you hear the prompt.
Audio Output Device
When Use Headphone For Prompt is turned off, you can hear prompts through the device's speaker. You
may prefer to hear prompts through a headphone or earphone. This allows you, but not others, to hear
the prompts.
To hear prompts through a headphone or earphone, plug stereo headphones or earphones into the
headphone jack on the side of the device. Then choose Menu > Settings > Use Headphone For Prompt.

Choosing and Adjusting a Prompt Voice

When choosing a voice to use for auditory prompts, it can be helpful to choose a different voice than
the one the system uses for speaking messages. To change the voice:
1. Choose Menu > Settings > Prompt Voice. A list of available voices opens.
2. To hear a voice before selecting it, tap the speaker icon located to the right of each voice.
3. When you decide which voice you want, tap the voice to select it.
4. Adjust the prompt voice rate and pitch as needed.
To adjust the prompt voice rate:
To adjust the prompt voice rate, choose Menu > Settings > Prompt Voice Rate and drag the slider to the
right to increase the rate or to the left to decrease the rate.
To adjust the prompt voice pitch:
To adjust the prompt voice pitch, choose Menu > Settings > Prompt Voice Pitch and select a pitch level:
Lowest, Lower, Low, Normal, High, Higher, or Highest.
PRiO User's Guide 63