Table of Contents
Advertisement
Controlling the Projector via LAN
Setting and Adjusting the
Projector
(Settings & Adjustments)
Example: "Picture" screen display for INPUT 1
On these screens, you can make projector
settings or adjustments. You can set or adjust
the following items :
Picture Mode
• • • • •
Bright Boost
• • • • •
CLR Temp
• • • • •
sRGB [OFF][ON]
• • • • •
• • • • •
IRIS
Signal Type
• • • • •
• • • • •
Auto Sync [OFF][ON]
Resize (INPUT 1)
• • • • •
• • • • •
OSD Display [OFF][ON]
Video System (INPUT 3/4)
• • • • •
• • • • •
Background
Eco Mode [OFF][ON]
• • • • •
Auto Power Off [OFF][ON]
• • • • •
Auto Focus (Startup) [OFF][ON]
• • • • •
Auto Keystone [OFF][ON]
• • • • •
Internal Speaker [OFF][ON]
• • • • •
Audio Out [OFF][ON]
• • • • •
• • • • •
Projection Mode
RS-232C Speed
• • • • •
• • • • •
Monitor Out (Standby)
OSD Language
• • • • •
Note
• If you click the "Refresh" button before the
screen is displayed completely, an error mes-
sage ("Server Busy Error") will be displayed.
Wait for a moment and then operate again.
• You cannot operate this page while the pro-
jector is warming up.
• For details about each item, refer to the
projector's operation manual.
14
Setting the Security
(Network – Security)
On this screen, you can make settings relat-
ing to security.
Items
User Name
Setting of user name for
security protection.
Password
Setting of password for
security protection.
Accept IP
It is possible to set up to three
Address
IP addresses allowing connec-
tion to the projector.
All IP
No limits are set to IP addresses
Addresses
connecting to the projector.
From only
For security improvement, only an
specific IP
IP address set by "Address 1-3"
addresses
can be connected to the projector.
Note
• User Name and Password can be up to 8
characters.
• You can input the characters below :
a-z, A-Z, 0-9, -, _
Description
Advertisement
Table of Contents
