Controlling The Projector Via Lan; Controlling The Projector Using Internet Explorer; (Version 5.0 Or Later) - Eiki EIP-3500 Setup Manual

Eiki eip-3500: install guide

Hide thumbs Also See for EIP-3500:

Table of Contents

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in "Address"

on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup

screen that will enable control of the projector via the network.

Controlling the Projector

Using Internet Explorer

Complete connections to external equipment

before starting the operation. (See pages 21-

28 of the projector's operation manual.)

Complete the AC cord connection. (See page

29 of the projector's operation manual.)

Note

• When connecting the projector to the LAN, use

a LAN cable (Category 5). When connecting the

projector to a hub, use a straight-through cable.

Start Internet Explorer (version 5.0

or later) on the computer.

Enter "http://" followed by the

projector IP address set by the

procedure on page

by "/" in "Address", and then

press the "Enter" key.

• The factory default setting for the projector

IP address is 192.168.150.2. If you did not

change the IP address in "3. Setting up a

Network Connection for the Projector"

(page 10-11), enter "http://192.168.150.2/".

A screen for controlling the pro-

jector appears, ready for per-

forming various status condi-

tions, control, and settings.

followed

Table of Contents