Setting And Adjusting The Projector (Settings & Adjustments); Setting The Security (Network - Security) - Eiki EIP-4500 Setup Manual

Setting and Adjusting the
Projector
(Settings & Adjustments)
Example: "Picture" screen display for INPUT 1
On these screens, you can make projector
settings or adjustments. You can set or adjust
the following items :
• • • • • Picture Mode
• • • • • CLR Temp
• • • • • Bright Boost
• • • • • Progressive
• • • • • C.M.S. Adjustment
• • • • • DNR
• • • • • Signal Type
• • • • • Auto Sync
• • • • • Auto Sync Disp
• • • • • Audio Out
• • • • • Internal Speaker [OFF][ON]
• • • • • Resize
• • • • • OSD Display
• • • • • Video System (INPUT 4/5)
• • • • • Background
• • • • • Startup Image
• • • • • Eco Mode [OFF][ON]
• • • • • Auto Search [OFF][ON]
• • • • • Auto Power Off [OFF][ON]
• • • • • Lamp Mode
• • • • • Projection Mode
• • • • • Keylock Level
• • • • • Set Inputs
• • • • • RS-232C Speed
• • • • • Monitor Out (Standby)
• • • • • OSD Language
• • • • • Video Wall (See page 41.)
• • • • • Stack Setting (See page 38.)
Note
• If you click the "Refresh" button before the
screen is displayed completely, an error mes-
sage ("Server Busy Error") will be displayed.
Wait for a moment and then operate again.
• You cannot operate this page while the pro-
jector is warming up.
• While the projector is in standby mode, you
can only control "Power ON".
• For details about each item, refer to the
owner's manual of the projector.
Controlling the Projector via LAN
Setting the Security
(Network – Security)
On this screen, you can make settings relat-
ing to security.
Items
User Name Setting of user name for
security protection.
Password Setting of password for
security protection.
Accept IP It is possible to set up to three
Address IP addresses allowing connec-
tion to the projector.
All IP No limits are set to IP addresses
Addresses connecting to the projector.
From only For security improvement, only an
specific IP IP address set by "Address 1-3"
addresses can be connected to the projector.
After clicking the "Apply" button, the set val-
ues appear. Confirm that the values are set
properly, and then click the "Confirm" button.
Note
• After setting items, wait for 10 seconds and
then re-access.
• User Name and Password can be up to 8
characters.
• You can input the characters below :
a-z, A-Z, 0-9, -, _
• To cancel User Name and Password, enter
nothing and then press "Apply" button.
Description
25