Controlling The Projector Via Lan; Controlling The Projector Using Internet Explorer (Version 5.0 Or Later) - Eiki DLP EIP-4500 Setup Manual

Hide thumbs Also See for DLP EIP-4500:

Table of Contents

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in "Address"

on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup

screen that will enable control of the projector via the network.

Controlling the Projector

Using Internet Explorer

(Version 5.0 or later)

Complete connections to external equipment

before starting the operation. (See pages 24-

36 on the owner's manual of the projector.)

Complete the AC cord connection. (See page

37 on the owner's manual of the projector)

Note

• When connecting the projector to the LAN, use a

commercially available LAN cable (UTP cable,

Category 5, cross-over type). When connecting

the projector to a hub, use a straight-through cable.

Start Internet Explorer (version 5.0

or later) on the computer.

Enter "http://" followed by the

projector IP address set by the

procedure on page

by "/" in "Address", and then

press the "Enter" key.

• The factory default setting for the projector

IP address is 192.168.150.2. If you did not

change the IP address in "3. Setting up a

Network Connection for the Projector"

(pages 21-22), enter "http://192.168.150.2/".

A screen for controlling the pro-

jector appears, ready for per-

forming various status condi-

tions, control, and settings.

Downloaded From projector-manual.com EIKI Manuals

followed

Table of Contents