Confirming The Projector Status (Status); Controlling The Projector (Control) - Eiki EIP-3000N Setup Manual

Controlling the Projector via LAN
Confirming the Projector
Status
(Status)
On this screen, you can confirm the projector
status. You can confirm the following items :
MAC Address
• • • • •
• • • • • Power
Condition
• • • • •
Lamp Timer
• • • • •
Lamp Life
• • • • •
Input
• • • • •
Signal Info
• • • • •
Serial Number
• • • • •
Note
• If you click the "Refresh" button before the
screen is displayed completely, an error
message ("Server Busy Error") will be dis-
played. Wait for a moment and then oper-
ate again.
• For details about each item, refer to the
owner's manual of the projector.
14
Controlling the Projector
(Control)
On this screen, you can perform projector
control. You can control the following items :
Power
• • • • •
Input Select
• • • • •
Volume
• • • • •
AV Mute [OFF] [ON]
• • • • •
Note
• If you click the "Refresh" button before the
screen is displayed completely, an error mes-
sage ("Server Busy Error") will be displayed.
Wait for a moment and then operate again.
• You cannot operate this page while the pro-
jector is warming up.
• While the projector is in standby mode, you
can only control "Power ON".
• For details about each item, refer to the
owner's manual of the projector.